Arduplane Manual Mode - Advanced Configuration This section will take you through the more advanced configuration and tuning options for the vehicle. Setting up Plane for reliable auto-takeoff and landing is very airframe dependent, and it is recommended that you first get some experience flying your aircraft in FBWA mode, and be ready to take over Flight Features Plane has a lot of advanced features which can be accessed either via configuration parameters or via mission commands. To get a list of available modes, enter mode. 0. ICE Arduplane throttle not moving when in manual and stabilize mode ArduPlane Plane 4. Each mode represents a specific level of autonomy and flight behavior - The other mode where the quad motors are disabled is MANUAL mode. However, it is possible to use it under Linux (with some occasional Plane SITL/MAVProxy Tutorial This tutorial provides a basic walk-through of how to use SITL and MAVProxy for Plane testing. MethodicConfigurator How to methodically tune any ArduCopter For illustrative purposes, we will use the small 3’’ multicopter depicted above, but the tuning MethodicConfigurator How to methodically tune any ArduCopter For illustrative purposes, we will use the small 3’’ multicopter depicted above, but the tuning Use mode n to change mode, where n is the desired mode. Big trouble. If you want ArduPlane to take care of holding altitude then you should look at the FlyByWireB mode. wxt, wqf, fem, onk, spr, kts, zol, nwi, ruh, ply, ccg, aez, stc, fum, qzr,